690 Enduro Forum

General Category => 690 Discussion => Topic started by: cornish mafia on February 16, 2017, 01:07:27 pm

Title: Help needed....PLEASE !!
Post by: cornish mafia on February 16, 2017, 01:07:27 pm
Ok.. Changed out my fuel filter and fuel pump for a Cycleworks one and replacement filter and now nothing the bloody bike just won't start... I've had the injector out and it's showing a fine spray of fuel , plug  out and it's sparking , air filter is new K&N so that's good as well. I figure as the injector is getting fuel that the hoses "must" be OK and as the fuels being delivered ? Filter going the right way etc , hoses seem to have gone in OK as like I said I have fuel at the injector ..... How much fuel should I be getting any videos to show ?

SO my plea for help is this .... WHAT HAVE I DONE WRONG ...This was meant to be a five minute job and i'm now on day three and trying my hardest not to throw a match at the thing and set it off in flames .... Talk about breaking your balls !! >:(

Bikes a 2012 690 enduro r  ...
Title: Re: Help needed....PLEASE !!
Post by: rider_marc on March 08, 2017, 02:35:47 pm
Any progress? Hope things are all well again.
Title: Re: Help needed....PLEASE !!
Post by: brian68 on April 15, 2017, 09:02:56 am
why did you change it? was it  running before? no trouble codes? try pulling the fuel line off the injector and hook up a pressure gauge and check the pressure. does it try to start?  if you have a kink in your line aka restriction it will build enough pressure to try and start or start for a couple seconds then die as the restriction won't allow it to maintain pressure.
Title: Re: Help needed....PLEASE !!
Post by: Vewsmewa on November 13, 2019, 12:35:46 am
I just knew it was this. If anyone has a question I can answer it. Maybe I will know some things.
Title: Re: Help needed....PLEASE !!
Post by: Jgensfth on March 20, 2020, 03:33:22 am
I am very pleased to be a member here. In order for me to access the data fully.