Author Topic: Help needed....PLEASE !!  (Read 95 times)

cornish mafia

  • Wanderer
  • *
  • Posts: 4
  • Karma: +0/-0
  • Location: Penzance Cornwall
    • View Profile
Help needed....PLEASE !!
« on: February 16, 2017, 01:07:27 pm »
Ok.. Changed out my fuel filter and fuel pump for a Cycleworks one and replacement filter and now nothing the bloody bike just won't start... I've had the injector out and it's showing a fine spray of fuel , plug  out and it's sparking , air filter is new K&N so that's good as well. I figure as the injector is getting fuel that the hoses "must" be OK and as the fuels being delivered ? Filter going the right way etc , hoses seem to have gone in OK as like I said I have fuel at the injector ..... How much fuel should I be getting any videos to show ?

SO my plea for help is this .... WHAT HAVE I DONE WRONG ...This was meant to be a five minute job and i'm now on day three and trying my hardest not to throw a match at the thing and set it off in flames .... Talk about breaking your balls !! >:(

Bikes a 2012 690 enduro r  ...

Social Buttons


rider_marc

  • Wanderer
  • *
  • Posts: 22
  • Karma: +0/-0
  • Location: Northern Middle Tennessee
    • View Profile
Re: Help needed....PLEASE !!
« Reply #1 on: March 08, 2017, 02:35:47 pm »
Any progress? Hope things are all well again.

brian68

  • Traveler
  • **
  • Posts: 40
  • Karma: +0/-0
  • Location: Philo, Ohio
    • View Profile
Re: Help needed....PLEASE !!
« Reply #2 on: April 15, 2017, 09:02:56 am »
why did you change it? was it  running before? no trouble codes? try pulling the fuel line off the injector and hook up a pressure gauge and check the pressure. does it try to start?  if you have a kink in your line aka restriction it will build enough pressure to try and start or start for a couple seconds then die as the restriction won't allow it to maintain pressure.